Mirror Board PS Mirror

INSTALLATION:

1.Use a rolling brush to evenly apply the adhesive on the back of the mirror board and the construction bottom plate (two adhesive surfaces are coated at the same time), finish the edge with a brush, and leave it for more than 15 minutes at room temperature and humidity below 70% (with the adhesive layer slightly non-stick hand prevail).

2.Apply the structural glue point on the back of the mirror plate, and the scraper will scrape the structural glue until it is smooth and uniform.

3.At one time, align with the bonding surface, extrude from inside to outside (eliminate bubbles), and compact the mirror plate.

4.After pasting, support the bottom gf the mirror plate with wooden square, remove it 24 hours later, and tear off the protective film on the surface of the mirror plate.